Turbo, few bits needed - UPDATED -

xsteven07 · Post by **xsteven07** » Wed Dec 17, 2014 5:32 pm

Hi all , i'm in need of a few bits ,Will collect if local to west-midlands , failing that i pay postage thank's

Needed

1, 220 turbo pas pipes

2, Bottom arms with the power flex bushes in

3, Where best place to get ARB bushes from ? ... 220 rack on and 220 sub-frame

4, A decent set of drive shafts

InB4Mike · Post by **InB4Mike** » Wed Dec 17, 2014 6:59 pm

Hi bud if your struggling for the drive shaft the ti ones are the same but you will need to switch the inner joint me thinks

Manifold bolts get stainless ones off ebay as they are better than the oe ones

Arms someone will have some

xsteven07 · Post by **xsteven07** » Wed Dec 17, 2014 8:10 pm

InB4Mike wrote:Hi bud if your struggling for the drive shaft the ti ones are the same but you will need to switch the inner joint me thinks

Manifold bolts get stainless ones off ebay as they are better than the oe ones

Arms someone will have some

Its got stainless ones in it which iv used but seem to be working they way loose :-/ stainless and alloy don't seem to mix IMO . i keep on the look out for a shaft thanks

Rovertech 2.0

Turbo, few bits needed - UPDATED -

Turbo, few bits needed - UPDATED -

Re: drive shafts and few bits needed

Re: drive shafts and few bits needed