Rover R8 220/420 2.0 T Series Engine Mounting's

[tony-f]

As above, I'm after the engine mounts, not the main rubber ones as ill be using Vibratech ones, mainly after all the brackets & plates etc and lower & upper stabilisers and the bolts would be a bonus but ill buy new where applicable as well as what ever else I can source.

Front Subframe too if anyone has one I already have a rear, also little bits like the throttle cable bracket that bolts to the bulkhead , clutch cable clamp that bolts to the rear alloy mount bracket , all pointless but nice original touches, All for a restoration of a genuine coupe turbo that I've acquired, unfortunately the whole front end is missing, possibly been stripped for a conversion, however I plan to save it over time.

Will add Photo of the diagram so people know what I'm talking about.

Will Pay postage or collect if not to far from myself ( Birmingham )

Cheers

Tony

[1234dist]

i have front subframe with stabiliser bars and a front engine mount (separate) £30 & £50 respectively.
Manchester.

[tony-f]

You say front mount , is that the main rubber one ?

[tony-f]

[1234dist]

#5 on the pic with the gearbox bracket as well

[vinny19791]

Am I right in thinking, with vibratech mounts you can do away with the stabiliser mounts?

[1234dist]

[tony-f]

Not going to be using the original rubber one , I just need #6 the gearbox bracket & front subframe

Yeah it states that you dont need them but I had them on a zr t I built along with all the stabilisers and a derv gearbox mount and it was solid and decent to drive

[russ220]

i got the dog bone mounts mate (21 & 23) , theyve been sat around since 2007 - look in good condition too.