Are there any 620 Ti owners in the Birmingham South area that could help me do some diagnostics on my Ti?
There's a few niggly issues with it and short of taking to a garage for them to charge me a fortune to tell me "it's a sensor problem" or something like that, i'm not really mechanically equipped to diagnose myself.
Bit of clutch judder here, bit of hunting/kangaroo'ing on gentle throttle there.
Could be anything!
West Midlands Diagnostics
Moderator: Forum Moderators
-
matt077
- RT GOD
- Posts: 7335
- Joined: Sun Jun 03, 2007 4:43 pm
- feedback: 789716
- Location: Birmingham
- Contact:
Re: West Midlands Diagnostics
clutch may be? my old mans rover75 did it, checked all the mounts and they was fine
thought at one point the gearbox was on its way out but turned out to be the clutch
thought at one point the gearbox was on its way out but turned out to be the clutch
Rover 25 turbo X reg - MG ZR Turborep
-
NoobCannon
- RT BiKiloPoster
- Posts: 2822
- Joined: Thu Jun 01, 2006 7:25 pm
- feedback: 524031
Re: West Midlands Diagnostics
juddering is more than likley clutch. One of the springs has prob broken, just had this problem myself and the hunting is gonna be an air leak more than likley the rubber part on the throttle body as it cracks overtime allowing air to leak into the intake when the engine moves.
Steve
Steve
221 Gti Turbo :- spec thread http://www.rt2468abcd.r8technology.co.uk/viewtopi ... 8#p1237168
-
Batch21
- Forum Regular
- Posts: 117
- Joined: Mon Aug 16, 2010 10:07 pm
- feedback: 1126680
- Location: Solihull, South Birmingham (WMids)
Re: West Midlands Diagnostics
Hmmm,
Ok, that's good advice guys, thanks. I've got a slave cylinder recon kit which i'm gonna fit over the weekend, to sort out my low bite (might also be clutch though) and i'll check all my piping (ooo'err) to see if i can see any cracks (ooo'err again).
Ok, that's good advice guys, thanks. I've got a slave cylinder recon kit which i'm gonna fit over the weekend, to sort out my low bite (might also be clutch though) and i'll check all my piping (ooo'err) to see if i can see any cracks (ooo'err again).
Re: West Midlands Diagnostics
Batch21 wrote:Hmmm,
Ok, that's good advice guys, thanks. I've got a slave cylinder recon kit which i'm gonna fit over the weekend, to sort out my low bite (might also be clutch though) and i'll check all my piping (ooo'err) to see if i can see any cracks (ooo'err again).
http://forums.mg-rover.org/showthread.p ... ve+Syringe
You might need to have a look at that link when bleeding the system after you fitted the new slave cylinder.
Gibbo
-
Punx0r
- Rovertech Moderator

- Posts: 32552
- Joined: Mon Nov 29, 2004 8:42 pm
- feedback: 538363
- Location: Northants
Re: West Midlands Diagnostics
Anthony | 1997 800 Vitesse Coupe, 1985 SD1 Vitesse
Re: West Midlands Diagnostics
i'm in brum mate so if you do need someone to have a look for ya, bring it to me and i'll have a gander. 

Of all the things i've lost in my life, i miss my mind the most. Ozzy
-
matt200vvc
- Forum Senior
- Posts: 332
- Joined: Wed May 02, 2007 4:08 pm
Re: West Midlands Diagnostics
Can't reccomend this option enough to you mate.... Gaz will sort your probelms out.420gazza wrote:i'm in brum mate so if you do need someone to have a look for ya, bring it to me and i'll have a gander.
BRG Coupe Turbo - Gone!
-
Batch21
- Forum Regular
- Posts: 117
- Joined: Mon Aug 16, 2010 10:07 pm
- feedback: 1126680
- Location: Solihull, South Birmingham (WMids)
Re: West Midlands Diagnostics
Gaz, since you have received such a glowing recommendation.....matt200vvc wrote:Can't reccomend this option enough to you mate.... Gaz will sort your probelms out.420gazza wrote:i'm in brum mate so if you do need someone to have a look for ya, bring it to me and i'll have a gander.
Where abouts are you fella?
PM me if you don't want to divulge on thread...don't want everyone just popping over for a cuppa when they feel like it